Ubee DVW32CB Installation Manual

Ubee DVW32CB Installation Manual

Advanced wireless voice gateway
Hide thumbs Also See for DVW32CB:

Advertisement

Ubee Interactive — www.ubeeinteractive.com
DVW32C Advanced Wireless Voice
Gateway - Safety and Installation
Product Insert
Federal Communications Commission
(FCC) Interference Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one of the
1
Ubee DVW32CB – Safety and Installation Product Insert v1.0
following measures:
 Reorient or relocate the receiving antenna
 Increase
the
separation
equipment and receiver.
 Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
 Consult the dealer or an experienced radio/TV
technician for help.

FCC Regulatory Information

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
There is one statement for this product:
 Only the type of PCB PIFA antenna tested
between
the

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DVW32CB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ubee DVW32CB

  • Page 1 There is one statement for this product: the equipment off and on, the user is encouraged  Only the type of PCB PIFA antenna tested to try to correct the interference by one of the Ubee DVW32CB – Safety and Installation Product Insert v1.0...
  • Page 2 3. Do not cover any ventilation openings in the operated at a minimum distance of 25cm device case. between itself and your body. 4. Do not place the device near heat sources Ubee DVW32CB – Safety and Installation Product Insert v1.0...
  • Page 3 15. This product must be installed upright. the AC wall outlet immediately. 9. The device should be installed in a location not to exceed the maximum temperature of degrees Celsius (104 degrees Ubee DVW32CB – Safety and Installation Product Insert v1.0...
  • Page 4 ETH4) on the device. Connect the other end to the ETHERNET port on a PC. Note: Category 5e or Category 6 Ethernet cables with RJ-45 connectors must be used when connecting Ethernet devices to the LAN ports. Ubee DVW32CB – Safety and Installation Product Insert v1.0...
  • Page 5 A 6.65+/-0.35 2. Remove the device from the product package. B 1.9+/-0.15 C 19.0+/1.20 3. Mount the device on the wall. 4. Refer to the following figure. The Screw’s Size (mm) Ubee DVW32CB – Safety and Installation Product Insert v1.0...
  • Page 6 OK, the LED is On. When the device performs a firmware upgrade, the LED flashes. On-line—When the device is obtaining an IP address and configuration file, the LED flashes. Ubee DVW32CB – Safety and Installation Product Insert v1.0...
  • Page 7 LED and charged. LED is Off if no battery is installed. flashes. If the battery is at low power level (30mins left), the battery LED will flash. Ubee DVW32CB – Safety and Installation Product Insert v1.0...

Table of Contents