Mounting The X-Gateway; Din-Rail Mounting - HMS Anybus X-gateway Modbus-TCP User Manual

Gateway hms anybus

Hide thumbs Also See for Anybus X-gateway Modbus-TCP:

Table of Contents

3.2 Mounting the X-gateway

The Anybus X-gateway can be physically installed either by mounting it onto a DIN-rail or, if installed

in areas exposed to vibration, by mounting it on a wall for more stability.

Anybus X-gateway for Modbus-TCP - Modbus-TCP

Doc.Rev. 1.00

About the Anybus X-gateway Modbus-TCP 16

Make sure the DIN-rail fastening mechanism on the back of

the module is in a fixed and closed position, i. e. pushed all the

way up.

To mount the module, first hook it on to the DIN-rail (1),

then push it against the DIN-rail to make it snap on (2).

To unmount the module, a screwdriver is needed. Use the

screwdriver to push the DIN-rail fastening mechanism on the

back of the module down until it locks in a fixed and open po-

sition (1). Then unhook the module from the DIN-rail (2).

Note: Do not leave the module with the DIN-rail fastening

mechanism in a fixed and open position. This may eventually

wear the fastening mechanism out so it cannot be used effi-

ciently. Be sure to push the DIN-rail fastening mechanism

back into the fixed and closed position after unmounting the

module.

Doc.Id. SCM-1200-114

Table of Contents

Do you have a question about the Anybus X-gateway Modbus-TCP and is the answer not in the manual?

Modbus-tcp