Configuring Printer For Dual Push Forms Path - IBM 3 User Manual

Configuring Printer For Dual Push Forms Path

Note: This procedure assumes you will be using the Front Push forms path and
then switching to the Rear Push forms path.
To configure the printer for the Dual Push forms path:
1. Power on (|) the printer
2. Wait until the message IBM 4247 appears, all the segments of the LCD on the
operator panel display arelighted, and the printer has stopped all motion.
3. Press Menu to enter configuration.
4. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Rear Tractor Use
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Rear Tractor Use
Push
7. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8. Press Return to return to the Configuration Menu.
9. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Printer Setup
10. Press Enter.
11. Press Scroll or Scroll until the printer displays
Printer Setup
Paper Source
12. Press Enter.
13. Press Scroll or Scroll until the printer displays
Paper Source
Front
14. If you are using the same type of forms in the front push and rear push
tractors and you want the printer when it runs out of forms in the front forms
path to automatically switch to the forms in the rear forms path, continue
with step 15.
or
If you are using one type of forms in the front push tractors and another type
of forms in the rear push tractors and you want the forms in the front push to
be the default forms, continue with step 20.
15. Press Enter
An asterisk (*) will be displayed in front of the selected value.
16. Press Return to return to the Printer Setup Menu.
Chapter 17. Setting Up Forms Paths
225