Emulation Mode - IBM 3 User Manual

3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for MPL is displayed.
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Emulation Mode

You can set Emulation Mode to the following values:
v 4247 (Default)
v 4224
v 4230
v 3287 (See Note 1)
v 3268 (See Note 1)
Notes:
1. If the IPDS feature is installed and you set Emulation Mode to 3287 or 3268,
2. The printer performs a partial reset to put any change to this parameter value
To change or check the emulation mode, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for Emulation Mode is
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"
Coax Configuration
Maximum Page Length
An asterisk (*) will be displayed in front of the selected value.
on page 55.
you cannot run an IPDS job.
into effect when you exit the Configuration Menu with Start or Return.
Buffered data will be lost.
CONFIGURATION MENU
Coax Configuration
Coax Configuration
Emulation Mode
displayed.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
Chapter 8. Coax Configuration
93