IBM 3 User Manual page 15

Printer
Documentation
Printer Driver Diskette
Wire Forms Guide
Figure 1. Contents of Shipping Container
Additionally, you can order the following options (not pictured here). Contact
your IBM marketing representative.
v Automatic Sheet Feeder - Allows feeding of envelopes or single sheets of
paper from as many as three additional cut-sheet paper trays
v Printer Stand - Provides adequate printer support, and especially helpful
when using the Dual Push forms path
v Network Print Server - Provides for ethernet 10Base2, ethernet 10BaseT,
token ring media type 1, or token ring media type 3 connectivity when
attached to the parallel interface at the rear of the printer
2. After opening the shipping container, have another person help you remove the
printer and place it on a table or the optional printer stand. If you select a table
as the permanent location, ensure:
v You have access to both the front and the rear of the printer.
v The table you select is sturdy enough to support the weight of the printer,
and firm enough to contain the action of the printer movement. To meet this
criteria, IBM recommends the optional printer stand which is available from
your IBM marketing representative.
3. Remove the remainder of the contents from the shipping container. (See
Appendix A, "Printer Specifications" for dimensions of the table or printer
stand surface and the clearances required around the printer.)
4. If you have not already done so, remove the plastic bag from the printer.
5. Lift the bottom edge of the front tractor cover into the open position.
(2nd tractor is optional)
Forms Tractor
Attachment Card
Operator Panel Overlay
Power Cord
Twinaxial connector
(if ordered)
Ribbon Cartridge
Interface Cable(s)
Chapter 1. Getting Started
5