Early Print Complete; Printer Compatibility 12 (Automatic Function Before Start Of Oilc Job) - IBM 3 User Manual

10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Early Print Complete

You can set this value to:
Enabled
Disabled (Default)
Note: The printer performs a partial reset to put any change to this parameter
To change or check the early print complete value, follow these steps:
10. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Printer Compatibility 12 (Automatic Function Before Start of OILC Job)

You can set this value to:
8. Press Scroll or Scroll until the desired value for suppress timeout on no
data loss intervention required is displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
The printer can send a "print complete" message before it is done printing
all of the data. This can improve throughput in some environments.
The printer can only send a "print complete" message after it finishes
printing all of the data.
value into effect when you exit the Configuration Menu with Start or
Return. Buffered data will be lost.
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
CONFIGURATION MENU
Coax Configuration
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
Coax Configuration
Printer Compatibility
5. Press Enter.
6. Press Scroll or Scroll until the printer displays
Printer Compatibility
Early Print Complete
7. Press Enter to display the current value.
8. Press Scroll or Scroll until the desired value for Early Print Complete is
displayed.
9. Press Enter.
An asterisk (*) will be displayed in front of the selected value.
on page 55.
Chapter 8. Coax Configuration
107