Alarm Control; Override Host / Paper Source - IBM 3 User Manual

4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for graphics mode is displayed.
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Alarm Control

You can set the audible printer alarm to either of the following values:
v Enabled (Default)
v Disabled
Note: Pressing Set Top of Form and some unit check conditions sound the alarm,
To change or check the alarm control, follow these steps:
1. Press Menu.
2. Press Scroll or Scroll until the printer displays
3. Press Enter.
4. Press Scroll or Scroll until the printer displays
5. Press Enter to display the current value.
6. Press Scroll or Scroll until the desired value for alarm control is displayed.
7. Press Enter.
8. Press Start or Return to exit the Menu. See "Exiting the Configuration Menu"

Override Host / Paper Source

Override Host is a selection that determines whether the printer uses or overrides
(ignores) the SCS paper source selection commands sent by the host. IPDS paper
source selection commands sent from the host cannot be overridden.
Note: This selection appears in the Twinax Configuration menu only if the
You can set the Override Host / Paper Source selection to either of the following
values:
Twinax Configuration
Graphics Mode
An asterisk (*) will be displayed in front of the selected value.
on page 55.
even if it is disabled.
CONFIGURATION MENU
Twinax Configuration
Twinax Configuration
Alarm Control
An asterisk (*) will be displayed in front of the selected value.
on page 55.
parameter Data Stream is set to SCS.
Chapter 7. Twinaxial Configuration
87