Installing Forms Tractor in Rear Pull Position
Paper Exit -
Rear Pull
This illustration shows the Rear Pull forms path from the left side of the printer.
Note: The forms path procedures always assume that a tractor not installed in the
printer is stored in the Push or fully-extended position. If you remove a
tractor from the Rear Pull or angled position, use the following procedure
before storing it:
v Place the tractor face down on a flat surface with the electrical connector
tab on the right side, pointing toward you.
v Pull the bottom release levers toward you with your finger tips and push
the movable edge of the tractor down toward the flat surface with your
thumbs (1) until the tractor locks in the fully extended position (2).
Installation Procedure
1. The power switch is located on the lower left side of the printer. Ensure that
the printer is powered off (O) before removing or installing forms tractors.
Power Switch
Chapter 17. Setting Up Forms Paths
Rear Pull
235