Control Timer Values (Seconds); Date And Time - ATCOM AT800D User Manual

AT800 Series User Manual
Control Timer Values (seconds)
Interdigit Long Timer‐‐‐If no candidate sequences are as yet complete (as dialed), the
Interdigit_Long_Timeout applies. Default is 10s. Range: 1 – 99sec
Interdigit Short Timer‐‐‐If a candidate sequence is complete, but there exists one or more
incomplete candidates, then the Interdigit_Short_Timeout applies. Default is 3s.Range: 1 – 99 sec
Recorder Delay‐‐‐Delay after far end hangs up before recorder tone is played. 0 = plays immediately,
inf = never plays. Range: 0 – 99 sec. Default is 5s.
Recorder Time‐‐‐The time of displaying call ended. If setting recorder time to 0, it will return to idle
state immediately without displaying call ended and playing recorder tone when call is hung up by
the other side.Range: 0 – 99 sec. Default is 12s.
Date and Time
NTP
1. NTP server‐‐‐Network Time Protocol. Set NTP Server, and both domain and IP address are
allowed.
2. Time zone‐‐‐Choose proper time zone of the local time.
Manual
1. Set Local Date (YYYY/MM/DD)‐‐‐Set a manual date by inputting in YYYY/MM/DD formate.
E.G. 2012/10/1. Or click the icon
2. Set Local Time(hh:mm:ss)‐‐‐Set a manual time by inputting in hh:mm:ss formate. E.G.
12:00:00. Or click up/down button to increase/decrease the value.
Note: In manual mode, the date and time will be reset after a restart.
Daylight Saving Time
ATCOM TECHNOLOGY CO., LIMITED
to choose the date on calendar.
www.atcom.cn