2. Plug in the power jack with DC 12V/500mA. 3. All Leds will be lighted once and then turn off. 4. After a absolute boot up, login led will be lighted in red and AT800 comes into stand by mode.
PPPoE. You can use either of these IP types to connect the internet. DHCP: DHCP: Use DHCP: DHCP: ----Select DHCP If you have a DHCP server in your network, AT800 will automatically obtain the network information from your DHCP server. ATCOM TECHNOLOGY CO., LIMITED...
Page 5
----Type your PPPoE dialup information in the PPPoE setting fields: PPPoE server (option), Username and password. Then connect AT800 to the Ethernet port of the modem, it will connect to the internet through PPPoE, and automatically obtain the IP address, Subnet Mask, Default Gateway, Primary DNS and Secondary DNS information.
Page 6
1. If [Remember account] is set to no, user needs a manual login on LCD every time the phone restarts. 2. After the restart, it will enter idle state and login led will be lighted in red. ATCOM TECHNOLOGY CO., LIMITED...
Login Login indicator indicator AT800 AT800 status status Red/flashing LAN disconnected Red/stable SIP unregister SIP register ok Then you can make calls when the LAN and SIP config are both correct. AT800 just supports headset calls. ATCOM TECHNOLOGY CO., LIMITED...