Epson Stylus PHOTO 890 Service Manual page 92

EPSON Stylus Photo 890/1280/1290
1. When handling CLEANER, HEAD, note the points below:
C A U T I O N
n
Do not touch CLEANER, HEAD with your bare hands.
Ware gloves or use tweezers.
n
Do not smear CLEANER, HEAD with oil or grease.
n
When installing CLEANER, HEAD, set the rubber side
(black side) facing to the right.
2. When replacing the Cap Assembly, do not touch its sealing
rubber part.
n
When assembling, make sure the Ink Tube is correctly placed
at the correct position. If not, it may cause an ink leakage.
1. When assembling the Cap Assembly to the Ink System
C H E C K
Assembly, make sure ABSORBER, SLIDER, CAP is assembled
P O I N T
in the cap assembly. ABSORBER, SLIDER, CAP should be set
as shown in Figure 4-15 in advance.
2. Check that the ink tube is securely connected to the connection
part of the Cap Assembly. (See Figure 4-16.) Also, make sure
the tube is not bent or crushed by the connection area. (See
Figure 4-17.)
3. Check that the ink tube is placed correctly in the Ink System.
(See to Figure 4-16.) Pay special attention in connecting the tube
to the Pump Unit. Connect the tube by strictly following the
instruction given in Figure 4-18.
4. When assembling, be careful not to crush or leave any stress on
the ink tube that connects the Pump Unit and Cap Assembly.
Also,
5. After installing the Pump Unit, ensure that CLEANER, HEAD
moves back and forth with rotation of the gear.
DISASSEMBLY AND ASSEMBLY
Figure 4-15. Setting the ABSORBER, SLIDER, CAP
Pump Unit
Disassembly Procedures
About 45
°
About 60-90
Cap Assembly
Ink Tube
Figure 4-16. Ink Tube Installation (1)
Revision C
°
ABSORBER,
SLIDER, CAP
92