Epson Stylus PHOTO 890 Service Manual page 102

EPSON Stylus Photo 890/1280/1290
8. Release the Hopper Assembly from the pin in the top left corner of ASF, FRAME;
B in the order indicated with arrows in the figure below.
Step 2
Figure 4-36. Hopper Assembly Removal (1)
9. Releasing the Hopper Assembly from the protrusion at the top right edge of
FRAME, ASF; B, detach the arm of the Hopper Assembly from the square cutout
in the right frame of FRAME, ASF; B.
Hopper Assembly
Figure 4-37. Hopper Assembly Removal (2)
DISASSEMBLY AND ASSEMBLY
Pin in FRAME, ASF;B
Hopper Assembly
Step 1
Cutout in FRAME, ASF; B
Disassembly Procedures
10. Using tweezers, remove the left and right compression springs (1.961) from the
Hopper Assembly and FRAME, ASF; B. (See Figure 4-38.)
11. Lifting up the right edge of SHAFT, ROLLER, LD a little, remove the shaft by
pulling it out to the right along with LD rollers. (See Figure 4-38.)
12. Remove the left LEVER, HOPPER, RELEASE from SHAFT, ROLLER, LD. (See
Figure 4-38.)
13. Remove the LD roller assemblies from SHAFT, ROLLER, LD. (See Figure 4-38.)
Revision C
102