Epson Stylus PHOTO 890 Service Manual page 123

EPSON Stylus Photo 890/1280/1290
8. Perform the PG adjustment to the left side.
Move the Carriage to the center of the printer mechanism. Put the PG adjustment
tool right on the leftmost rib of Paper Guide Front.
C H E C K
Make sure to align the edge of the PG adjustment tool on the
P O I N T
leftmost part of Front Paper Guide with the jut out portion of the
tool (bottom part) placed on the rear ditch of Front Paper Guide.
9. Set the Left Parallel Adjustment Bushing forward. By moving the bushing to the
back one notch at a time, find the position where the printhead touches the PG
adjustment tool. From the touching point, move the bushing forward (Wider PG
direction) by one notch
10. Move the PG lever to the rear (+).
11. Move the Carriage Unit over the PG adjustment tool on the left.
12. Bring the PG lever to the front (0).
13. Make the adjustment as in the same manner as in step 6 and 7.
14. Bring the PG lever to the rear (+).
15. Move the carriage back over the PG adjustment tool on the right.
16. Move the PG lever back to the front (0).
17. Make the adjustment again on the Right Parallel Adjustment Bushing. If the result
is good, the adjustment is completed.
18. Fasten the bushing screws on both sides.
ADJUSTMENT Adjustment
Revision C
123