Epson Stylus PHOTO 890 Service Manual page 87

EPSON Stylus Photo 890/1280/1290
5. Remove 1 screw (CBP, 3x8) securing Panel Unit to the printer mechanism and
release the pins fit in the printer mechanism.
Then remove the Panel Unit along with HOUSING, REINFORCING, RIGHT.
CBS (3x6)
HOUSING,
REINFORCING, RIGHT
Figure 4-6. Panel Unit Removal
DISASSEMBLY AND ASSEMBLY
Pins
Panel Unit
CBS (3x6)
Cutout
Disassembly Procedures
6. Remove 2 screws (CBP, 3x8) securing SHIELD PLAT, PANEL to the Panel Unit,
and then remove SHIELD PLATE, PANEL.
SHIELD PLATE, PANEL
CBP (3x8)
BOARD ASSEMBLY, PANEL
Cup P-Tite (3x6)
Harness
Figure 4-7. BOARD ASSEMBLY, PANEL Removal
7. Remove screws (CBP, 3x8 & Cup P-Tite, 3x6) securing BOARD ASSEMBLY
PANEL to the Panel Unit.
8. Disconnect the harness from BOARD ASSEMBLY, PANEL.
C A U T I O N
When removing the Panel Unit, watch out for the stacker
assembly. Since the stacker assembly is attached to the Panel
Unit and HOUSING, PANEL, LEFT, if you remove the Panel
Unit, the stacker assembly will also come off.
Revision C
CBP (3x8)
CBP (3x8)
87