Epson Stylus PHOTO 890 Service Manual page 105

EPSON Stylus Photo 890/1280/1290
n
When installing the edge guide to the left LD Roller Assembly,
C H E C K
ensure that the rib in the LD Roller Assembly fits correctly into
P O I N T
the groove in the edge guide. (See Figure 4-41.)
n
Make sure that the right LD Roller Assembly is fixed with the
hook in FRAME, ASF; B. You can check its condition from the
back of the ASF Unit. (See Figure 4-42.)
n
Before assembling the ASF Unit, hold each compression spring
(1.961) with the hook of the spring bearing in the Hopper
Assembly. Then, after attaching the Hopper Assembly to
FRAME, ASF; B, release the springs from the hooks through
the cutouts in the back of the frame. (See Figure 4-43.)
Groove in the Edge Guide
Rib in the LD Roller Assembly
Figure 4-41. LD Roller Assembly Installation (2)
DISASSEMBLY AND ASSEMBLY
Hook in the FRAME, ASF; B
Figure 4-42. Hook Fixing the LD Roller Assembly
Figure 4-43. Holding Compression Spring with the Hooks
Disassembly Procedures
Compression
Hooks
Spring 1.961
Revision C
105