EPSON Stylus Photo 890/1280/1290
4.2.5 TRAY, ABSORBER ASSEMBLY Removal
1.
Remove HOUSING. (Refer to Section 4.2.1.)
2.
Remove the Panel Unit. (Refer to Section 4.2.3.)
3.
Remove 2 screws (CBS, 3x6) securing HOUSING, PANEL, LEFT to the front left
part of the printer mechanism.
Pin
CBP (3x8)
HOUSING, PANEL, LEFT
Figure 4-11. HOUSING, PANEL, LEFT Removal
4.
Remove 1 screw (CBP, 3x8) securing HOUSING, PANEL, LEFT to the
HOUSING, SUB, LEFT.
5.
Release the pin fixing HOUSING, PANEL, LEFT to the printer mechanism, and
then remove HOUSING, PANEL, LEFT toward the front.
C A U T I O N
When removing HOUSING, PANEL, LEFT, watch out for the
Stacker Assembly. Since the Stacker Assembly is fixed by the
Panel Unit and HOUSING, PANEL, LEFT, it will come off as
HOUSING, PANEL, LEFT is removed.
DISASSEMBLY AND ASSEMBLY
CBS (3x6)
Disassembly Procedures
6.
Remove 2 screws (CBS, 3x6) securing HOUSING, SUB, LEFT to the printer
mechanism.
7.
Release 3 hooks (2 at the bottom and 1 in the front) fixing HOUSING, SUB, LEFT
to the printer mechanism, and remove HOUSING, SUB, LEFT.
8.
Remove 1 or 2 screws (CBP, 3x6: Stylus Photo 890 1 screw, Stylus Photo 1290 2
screws) securing PAPER GUIDE, LOWER to TRAY, ABSORBER ASSEMBLY
at the middle of the printer mechanism, and then remove PAPER GUIDE,
LOWER.
CBP (3x8)
ABSORBER,
WASTE INK,
TRAY, ABSORBER
LARGE/SMALL
CBP (3x8)
Figure 4-12. TRAY, ABSORBER ASSEMBLY Removal
Revision C
Hook in TRAY,
FRAME,
ABSORBER
SPACER, TRAY
PAPER GUIDE,
LOWER
89