Epson Stylus PHOTO 890 Service Manual page 104

EPSON Stylus Photo 890/1280/1290
n
While assembling the ASF Unit, be careful not to smear any
C H E C K
parts with oil on the cam parts. If oil gets other parts, it should
P O I N T
be wiped off.
n
When installing LEVER, HOPPER, RELEASE, set it in the
correct direction. (See Figure 4-39.)
n
Be sure to attach the following parts to SHAFT, ROLLER, LD
securely. (See Figure 4-38.)
- BUSHING, FIXING, SHAFT, LEFT (white plastic part)
- WHEEL, DETECTOR (black plastic part)
n
When installing the LD Roller Assemblies to SHAFT,
ROLLER, LD, make sure the black one (right LD Roller
Assembly) goes to the right.
n
When setting the right and left LD Roller Assemblies, align
their grooves with the rail rib in FRAME, ASF; B. (See Figure
4-40.)
DISASSEMBLY AND ASSEMBLY
Figure 4-39. LEVER, HOPPER, RELEASE Installation
Figure 4-40. LD Roller Assembly Installation (1)
Disassembly Procedures
LEVER, HOPPER,
RELEASE
Groove in the LD Roller
Assembly
Rail Rib in FRAME, ASF; B
Revision C
104