Setting Up a HTRD400 System Network
Stand-alone operation — recording mode
PC or laptop connected — Playback mode or Configuration mode
Overview of Installation Procedure
Rev 1.02
Figure 2-1
shows a stand-alone network with all system components co-located in a bus or
transit vehicle. For more information on system networking, see
Figure 2-1
Stand-alone Network
HTRD400 Recorder
HTRD400 Recorder
The initial installation of an HTRD400 system consists of the following steps:
1.
Choose a location to mount the HTRD400 Recorder.
2.
Mount the HTRD400 Recorder.
3.
Wire the HTRD400 Recorder to the electrical system on the vehicle via the Interface
port.
4.
Wire the triggers.
HTRD400 System Reference Guide
Standard PC or laptop
connection CAT5
Ethernet crossover
cable
9
Appendix
C.
Document 900.0328
05/05