Install Batteries In Wireless Devices; Link All Devices To Wireless Network - Honeywell RedLink Installation Manual

1

Install batteries in wireless devices

When system wiring is complete and TrueZONE panel is configured for RF,
install batteries in all devices. Make sure batteries are inserted properly (see
illustrations below).
Thermostat
Remote control (optional)
2

Link all devices to wireless network

Press
CONNECT
Flashing status light times out after 15
minutes of inactivity. Press
necessary.
Install 2 fresh AA
batteries
Install 3 fresh AA
batteries
again if
CONNECT
Español: vea la página 16 • Français : voir la page 31
Outdoor air sensor (optional)
Make sure the Connected light on the
wireless adapter is flashing green.
If the light stops flashing before you
have linked all devices, press
again.
If light does not flash, another EIM/wireless
adapter may be in wireless setup mode. Exit
wireless setup at the other EIM/wireless
adapter.
3
Programmable models only
Install quick reference card
Install 2 fresh AA
lithium batteries
CONNECT
Continued on next page >>