Connecting The Wiring Harness; Connecting The Power Supply; Figure 2-5 Wiring Connections - Honeywell HTRD400 Reference Manual

Connecting the Wiring Harness

DB25 INTERFACE
connector

Connecting the Power Supply

Rev 1.02
Figure 2-5 shows how to connect the wiring harness to the electrical system on the vehicle.
Caution Start the cabling at the HTRD400 Recorder unit to ensure that the
DB25 INTERFACE connector is not damaged and to allow for excess
wire to be removed.
Figure 2-5 Wiring Connections
20 foot cables
Signal feature harness
Note For DB25 connector pinouts, see
151.
After you have completed the wiring:
1. Plug the DB25 connector on the wiring harness into the rear panel of the HTRD400
Recorder and tighten the retaining screws.
HTRD400 System Reference Guide
Power
Power harness
Red Red Input on HTRD4GPS module
Black Black Input on HTRD4GPS module
White HTRD4GPS module via DB9 adapter cable
Green
25-Pin Interface Connector
15
Triggers 1 to 8
Red Battery (POS)
Black Battery (NEG)
Brown Input signal 2
White Input signal 1
Black Input signal 3
Green Input signal 4
Red Input signal 5
Blue Input signal 6
Yellow Input signal 8
Orange Input signal 7
Pinouts, page
Document 900.0328
05/05