Table 5-8 Camera Setup Fields - Honeywell HTRD400 Reference Manual

Table 5-8 Camera Setup Fields
Field
Name
MAC
Enable Audio
Rev 1.02
Note If you are hearing audio feedback through your speakers (on the Aim & Focus
screen), click Mute.
Description
Create a unique name for the camera (for example, Bus8710Main-Camera).
The name can be up to 20 characters in any combination of:
a-z, A-Z, 0-9
, (comma)
. (period)
- (hyphen)
#
*
"
Note You can assign a camera name without being connected (see
Camera address. Offline indicates the camera is not yet connected to the
HTRD400 Recorder. This is a status only (non-editable) field.
Must be enabled for audio to be recorded with video from the camera. Options
are:
Enabled
Disabled
Not supported. This field is grayed out if the camera does not support audio.
Note If Camera 1 supports audio, that will be the audio source used by the
Player. If Camera 1 does not support audio, the Player application will
search until it finds an enabled camera that supports audio and has
audio enabled.
6. After you have configured all the connected cameras, you must place them in the
order that you wish them to appear in the Player quad screen (see the Coverage
screen in Figure 5-10 for a graphical representation). That is, Camera 1 (top of the list)
will appear in the top left corner, Camera 2 in the top right corner, Camera 3 in the
bottom left corner, and Camera 4 (last in the list) in the bottom right corner.
HTRD400 System Reference Guide
53
Table 5-1).
Document 900.0328
05/05