Table of Contents
Advertisement
Factory Set Configurations
Using a Factory Set Configuration
Rev 1.02
To use any of the configurations described, you must first:
1.
Install your HTRD400 System (see
2.
Start the Toolbox application and connect to the HTRD400 Recorder. If password
protection has been enabled, you are prompted to log in.
3.
Set the recorder date and time and enable Daylight Saving Time if desired).
Complete the following steps in the order presented to set the configuration for your unique
system:
1.
Open the HTRD400 System Setup Wizard by clicking Start Wizard ... on the Task
Overview tab, then load the desired canned configuration from
C:\BusView\Configurations\. Click Next.
2.
Rename the recorder, then click Next.
Chapter 2
to
Chapter
124
4).
Document 900.0328
05/05
Advertisement
Table of Contents
