Table of Contents
Advertisement
Commands
5.3.19 UNLOGALL Remove All Logs from Logging Control
This command disables all logs on the specified port only. All other ports are unaffected.
This command does not disable logs that have the HOLD attribute set. (See the LOG command in Section
5.3.10 on Page 59 for more information on this attribute). To disable logs with the HOLD attribute, use the
UNLOG command.
Syntax:
UNLOGALL [ PORT ]
Field
Field
Name
1
header
2
port
3
Reserved (always 0).
Example:
UNLOGALL
EuroPak-15a Receiver User Manual Rev 5
Valid Values
This field contains the Abbreviated ASCII command name. See Section 4.1 on
Page 31.
See Table 10 on Page 39.
Description
Serial port at which logging is to
disabled. If a value is not provided,
COM1 is assumed.
Chapter 5
Message ID: 38
Binary
Binary
Format
Bytes
Offset
H
0
Enum
4
H
Enum
4
H+4
69
Advertisement
Table of Contents
