Table of Contents
Advertisement
Chapter 5
5.3.14 SDLLBW Configure DLL Filter Bandwidth
This is the noise equivalent bandwidth command for the signal channel DLL filter bandwidth.
1.
The SDLLBW command should only be used by advanced users. It may not be suitable for every
application. When using SDLLBW in a differential mode, the same setting should be used at both the
monitor and remote station.
2.
When you issue the SDLLBW command, all channels lose lock and the locktime for all tracking
satellites is reset to zero.
3.
The measurement becomes noisier as the DLL bandwidth increases.
Syntax:
SDLLBW
DSIGCHAN
Field
Field
Name
1
header
2
dsigchan
3
bw
Example:
SDLLBW 0 0.01
64
BW
Valid Values
Description
This field contains the Abbreviated ASCII command name. See
Section 4.1 on Page 31.
The parameters should be applied
0-15
to this signal channel.
Noise equivalent bandwidth of
0.001-0.5
DLL filter in Hz.
Binary
Format
Bytes
H
Ulong
4
Float
4
EuroPak-15a Receiver User Manual Rev 5
Commands
Message ID: 800
Binary
Offset
0
H
H+4
Advertisement
Table of Contents
