Pf Roller Assembly Removal - Epson Stylus Photo 720 Service Manual

EPSON Stylus Photo 720 / EPSON Stylus Photo EX3

4.2.5.10 PF Roller Assembly Removal

1. Remove the Housing.(See "Housing Removal" on page 68)
2. Remove the ASF Assembly. (See "ASF Assembly Removal" on page 80)
3. Remove the Torsion Spring117.6 from the rear side of the Top Frame and remove the
Upper Paper Guide Assembly toward the rear side of the printer. The number of the
Upper Paper Guide Assemblies differs between Stylus Photo 720 and Stylus Photo
EX3. (Stylus Photo 720: 5, Stylus Photo EX3:7)
When removing the Right Paper Guide Assembly, be careful for PE Sensor Lever
Head and remove it toward the front side of the printer.
Upper Right Paper
Guide Assembly
Front Side of the Printer
Figure 4-44. Paper Guide Assembly Removal
4. Remove 3 screws and remove the Front Frame from the Printer Mechanism. (See
Figure 4-45.)
5. Remove 2 screws to remove the Paper Eject Frame from the Printer Mechanism. When
removing the Paper Eject Frame from the Printer Mechanism, shift the CR Unit to the
CR Shaft left direction by hand and remove it from the Paper Eject Frame toward the
front side of the Printer Mechanism. Then shift the CR Unit to the center of the CR
Shaft and remove the left side of the Paper Eject Frame toward the front side of the
printer. (See Figure 4-45.)
Disassembly and Assembly
Spring Holders
Rear Side of the Printer
Front Frame Fixing Screws
Figure 4-45. Front Frame and Paper Eject Frame Removal
6. Release 2 hooks securing the Front Paper Guide to the Paper Eject Roller and remove it
to the front side of the printer.
Front Paper Guide
Securing Hooks
Figure 4-46. Front Paper Guide Removal
Disassembly
Paper Eject Frame
Fixing Screws
Front Paper Guide
Revision A
91