Epson Stylus Photo 720 Service Manual page 84

EPSON Stylus Photo 720 / EPSON Stylus Photo EX3
The following is the ASF Assembly exploded diagram.
Brake Lever
Torsion Spring 41.2
Left Hopper Lever
Stylus Photo 720:
Left LD Roller
Fixing Bushing
Stylus Photo EX3:
(White)
Left LD Roller
Fixing E-Ring
LD Roller Assembly
Figure 4-29. ASF Disassembly
Disassembly and Assembly
Hopper Assembly
ASF Frame
Right Hopper
Release Lever
Stylus Photo 720:
Right LD Roller
(Black)
Fixing Bushing
Stylus Photo EX3:
Right LD Roller
LD Roller Shaft
Fixing E-Ring
During disassembly and assembly of the ASF Hopper Assembly,
n
C H E C K
do not let the grease on the cam parts touch other parts. Wipe off
P O I N T
any grease smeared on other parts.
Be careful of the direction of the Hopper Release Lever when
n
installing it. (Refer to Figure 4-30.)
Make sure the LD Roller Assembly is installed firmly to the rail
n
of the ASF Frame. (Refer to Figure 4-31.)
Make sure the Left Frame of the left LD Roller Assembly is set to
n
the cutoff of the Paper Edge Guide. (Refer to Figure 4-32.)
When installing the right and left LD Roller Fixing Bushings (for
n
Stylus Photo EX3, LD Roller Fixing E-rings), make sure the
bushings are firmly installed and do not slip off. Also, make sure
the Black LD Roller Assembly goes on the right side of the shaft.
(Refer to Figure 4-30 below.)
Right Hopper Release Lever
Figure 4-30. Hopper Release Lever Installation Direction
Disassembly
Revision A
84