EPSON Stylus Photo 720 / EPSON Stylus Photo EX3
4.2.1 Housing Removal
Since this printer has no lower Housing, the Printer Mechanism is exposed just by
removing the Housing.
1.
Open the Printer Cover and set the PG Adjust Lever to (+) position.
2.
Remove 4 screws and remove the Housing.
C H E C K
When removing the Housing, be sure to keep the Housing out of
P O I N T
carriage: Pull the Housing toward the printer front side and lift it
upward.
When installing the Housing, be careful not to pinch the cable with
the screw at the rear side of the Housing.
Make sure the Head FFC is set properly inside the rail on the back of
the Housing.
Disassembly and Assembly
Disassembly
Figure 4-2. Housing Removal
Revision A
Housing
68