Cr Motor Assembly Removal - Epson Stylus Photo 720 Service Manual

EPSON Stylus Photo 720 / EPSON Stylus Photo EX3

4.2.5.3 CR Motor Assembly Removal

1. Remove the Housing.(See "Housing Removal" on page 68)
2. Rotate Combination Gear, 12.4, 28 toward the front of the printer and disengage the
CR Lock Lever. Then, manually move the CR Assembly to the center of the platen.
3. Push the Driven Pulley Holder toward the interior of the Left Frame and loosen the
Timing Belt. Remove the Timing Belt from the CR Motor Pinion Gear or pull the
Driven Pulley Assembly diagonally from the Driven Pulley Holder to the top (refer to
the arrow in the figure below.).
Compression Spring 19.6
To the Exterior
of Side Frame
Figure 4-13. Timing Belt Removal
4. Remove 2 screws securing the CR Motor, and remove CR Motor Assembly.
C H E C K When installing CR Motor Assembly, be sure that 2 projections of
P O I N T
the Motor Bracket are inserted to the position marking holes of the
frame.
Disassembly and Assembly
Driven Pulley Assembly
Timing Belt
To the Interior of
Driven Pulley
Side Frame
Holder
Top Frame
T h e p r o j e c t i o n s o f m o t o r a s s e m b l y m u s t
l o c a t e i n s i d e t h e h o l e s
Figure 4-14. CR Motor Assembly Removal
A D J U S T M E N T
After replacing CR Motor Assembly, perform
R E Q U I R E D
the Bi-D adjustment. (See "Bi-Directional Adjustment" on
page 106)
Disassembly
Revision A
77