Pf Roller Assembly Removal - Epson Stylus Photo Service Manual

EPSON Stylus Photo

3.2.5.7 PF Roller Assembly Removal

1. Removing the upper housing. (Refer to section 3.2.1)
2. Removing the carriage assembly (Refer to section 3.2.5.6)
3. Remove 2 screws (No.1) at the top of mechanism and remove "GUIDE PLATE, CABLE".
4. From the back of the mechanism, unhook the springs from the frame and remove "PAPER GUIDE,
ASSEMBLY, UPPER" (total 6 pieces).
5. Unhook "PAPER GUIDE, FRONT;B" and remove it.
6. Unhook the both shaft holders of "ROLLER, ASSEMBLY, PAPER EXIT" and remove it.
7. Unhook the left shaft holder of "ROLLER, ASSEMBLY, PF" and rotate it as to match with the cut out of
the frame.
8. Slide "ROLLER, ASSEMBLY, PF" to the left and pulling it out.


When reinstalling "PAPER GUIDE, ASSEMBLY, UPPER" at right-most position (viewed from the
front), be careful with the detection lever of the PE sensor.


Be careful not to damage the hook of "PAPER GUIDE, FRONT;B" during disassembly and
assembly.


Be careful not to damage the black coated part of "ROLLER, ASSEMBLY, PF" during
disassembly and assembly.


Be careful not to damage the gears.
3-24
WORK POINT
Figure 3-21. PAPER GUIDE ASSEMBLY Removal
Rev. A