Cr Motor Assembly Removal - Epson Stylus Photo Service Manual

EPSON Stylus Photo

3.2.5.3 CR Motor Assembly Removal

1. Removing the upper housing. (Refer to section 3.2.1)
2. Rotate "Gear, 67.2" (largest gear at the left-hand side of the printer mechanism) toward the front to
disengage the carriage lock mechanism, and move the carriage assembly to the middle of the printer.
3. Push "HOLDER, PULLEY, DRIVEN" inward to loosen the timing belt and detach the timing belt from
the drive pulley of CR Motor assembly.
4. Remove 2 screws (No.1) and remove "MOTOR, ASSEMBLY, CR" from the mechanism.
Be sure that the projections of the motor bracket is inserted to the holes of the frame properly.
When you replace "MOTOR, ASSEMBLY, CR", be sure to perform the following adjustment:
1) Bi-D Alignment Adjustment (Refer to Chapter 4 / Section 4.2.2.6.)
3-14
WORK POINT
REQUIRED ADJUSTMENT
Figure 3-12. Driven Pulley Removal
Rev. A