Cellular - ProSoft Technology RLXIC-EH User Manual

Configuration Commands
User Manual
10.5

Cellular

This group includes commands specific to HSDPA, EDGE and GPRS. If you are
not connecting to a modem which uses HSDPA, EDGE, or GPRS, you will not
see this group in the menu.
*NETAPN=apn
Easy entry of the APN. If left blank, the modem will attempt to use the default
subscriber value as defined by the account.
apn=access point name
*RXDIVERSITY
Enables or disables antenna diversity.
+COPS=mode,[format][,oper]
Manually specify an operator. Refer also to *NETOP.
mode=0 : Automatic - any affiliated carrier [default].
mode=1 : Manual - use only the operator <oper> specified.
mode=4 : Manual/Automatic - if manual selection fails, goes to automatic
mode.
format=0 : Alphanumeric ("name") (G3x10 must use this format).
format=2 : Numeric
oper="name"
+CGQREQ
Set Quality of Service Profile. Change should be at carrier's request. Normally
not required to be changed.
+CGQMIN
Minimum Acceptable Quality of Service Profile. Change should be at carrier's
request. Normally not required to be changed.
ProSoft Technology, Inc.
May 29, 2009
RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks
RLXIC-EH ♦ Intelligent Cellular
Page 99 of 111