ProSoft Technology RLXIC-EH User Manual page 88

RLXIC-EH ♦ Intelligent Cellular
RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks
Note: This is not normally used nor needed by user applications.
*HOSTNETMASK=n.n.n.n
Subnet mask for the host interface. Allows communication with a subnet behind
the host interface.
n.n.n.n = subnet mask, example 255.255.255.0.
*HOSTAUTH=n
Host Authentication Mode: Use PAP or CHAP to request the user login and
password during PPP or CHAP negotiation on the host connection. The
username and password set in *HOSTUID and *HOSTPW will be used.
n=0 : Disable PAP or CHAP request (Default).
n=1 : PAP and CHAP.
n=2 : CHAP
*HOSTUID=string
Host User ID for PAP or CHAP.
string=user id (up to 64 bytes)
*HOSTPW=string
Host Password for PAP or CHAP.
string=password
*DHCPSERVER=n
Act as a DHCP server for any Ethernet device connecting to the RLXIC-EH.
DHCP (Dynamic Host Configuration Protocol) allows one device, the DHCP
server, to provide dynamic IP addresses to any other device which requests
them.
n=0 : Disabled. The RLXIC-EH will not send out replies to DHCP requests.
n=0 : Disabled (cannot be configured in AceManager).
n=0 : Disables the DHCP server.
n=1 : Enabled. The modem will act as the primary DHCP server for the
network.
n=2 : Enabled if no other DHCP server is detected (default). If another DHCP
server is detected on the network, the RLXIC-EH will not send out replies to
DHCP requests.
n=0 : Disabled. The RLXIC-EH will not send out replies to DHCP requests.
Page 88 of 111
Configuration Commands
User Manual
ProSoft Technology, Inc.
May 29, 2009