Resetting The Type Adjust; Adjusting Print Density - Oce WP20 Operation Manual

Resetting the Type Adjust

Resets the custom settings (Custom1 to 8) that are set in
Customizing Paper Type on page 1-19
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key.
4 Press the or
Type Adjust appears.
>Reset Type
Adjust
5 Press the ENTER key. A question mark (?) appears.
>Reset Type
Adjust ?
6 Press the ENTER key. All the customized paper
weight and duplex path settings will be reset to the
default. The message display returns to Ready.
.
key repeatedly until Paper
key repeatedly until >Reset
Chapter 1 Using the Operator Panel

Adjusting Print Density

The print density can be adjusted in five steps: from 01 (light)
to 05 (dark). The default setting is 03.
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key.
4 Press the or
Adjust > appears.
>Type Adjust
Custom 1
5 Press the key.
6 Press the or
Density appears.
>>Print Density
03
7 Press the ENTER key. A blinking question mark (?)
appears.
>>Print Density
03
?
8 Select the print density from five steps from 01
(light) to 05 (dark) using the
9 Press the ENTER key.
10 Press the MENU key. The message display returns to
Ready.
This finishes the custom paper type settings.
key repeatedly until Paper
key repeatedly until >Type
>
key repeatedly until >>Print
or key.
1-21