Move And Re-Adjust The Printing System - Oce plotwave 345 Operation Manual

Move and re-adjust the printing system

Move and re-adjust the printing system
Introduction
When you move the printing system to a new location, you must check if it needs re-adjustment
to ensure the best output quality.
You need two tools for the adjustment procedure. You can find these tools behind the lower right
front cover.
Required tools
Allen key and Key wrench
IMPORTANT
• When the printer is connected, you must first switch off and disconnect the printer (see
off the printing system on page 213
cable on page
• Close the media drawers.
NOTE
Be aware of the size of the printer working area (see
Procedure
1. Release the wheel brakes and move the printing system to its new location.
2. When the system is at the right place, lock the brakes.
3. Pull firmly to open the media drawer.
216 Chapter 5 - Maintain the Printing System
215).
and Disconnect the network cable and the mains supply
Working area (Footprint) on page
Turn
19).