Setting Number Of Copies; Selecting Reduced Print - Oce WP20 Operation Manual

Chapter 1 Using the Operator Panel

Setting Number of Copies

You can set the number of copies to be printed of each page
for the current interface. The number of copies can be set be-
tween 1 and 999. The number of copies can be set whenever
the message display indicates Ready.
1 Press the MENU key.
2 Press the or
appears.
Page Set
3 Press the key.
4 Press the or
pears.
>Copies
5 Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
>Copies
6 Press the or
ue of the figure where the cursor is blinking. It can
be set between 1 and 999. You can use the
keys to move the cursor right and left.
7 When the desired size is displayed, press the ENTER
key.
8 Press the MENU key. The message display returns to
Ready.
1-30
key repeatedly until Page Set >
>
key repeatedly until >Copies ap-
001
001
key to increase or decrease the val-

Selecting Reduced Print

You can print with the reduced size. This menu is used to set
the source paper size and the paper size to use after reduc-
tion.
NOTE
• Printed results when making reductions differ from equivalent
size printing. Sometimes the line width of characters may not
be consistent or lines may appear in figures or image patterns.
Also, thin lines may not be reproduced on the reduced print.
• In the reduction mode, printed barcodes may not be read.
Bring up the Zoom menu. The following display will appear.
>Zoom
Source size indicator...This is the paper size before reduc-
tion.
This must be the same as the paper size set for print data
from the computer.
Target size indicator...This is the paper size after reduction.
This must be the same as the paper size set for the paper cas-
sette.
and
[CS]→[CS]
Target size indicator
Source size indicator