Table of Contents
Advertisement
Chapter 1 Using the Operator Panel
Using Quick Copy
This mode enables you to print the requested number of cop-
ies of a job, simultaneously storing the job on the hard disk.
When additional copies are required, you can reprint the re-
quired number of copies from the printer operator panel. To
print a job as a quick copy job, see
The default number of print jobs that can be stored on the
hard disk is 32. This value can be increased to up to 50 from
the e-MPS Configuration menu. For details, see
Maximum Number of Quick Copy/Proof-and-Hold Jobs on
page 1-40
. When the number of jobs reaches the limit, the old-
est job will be overwritten by the new one.
When the printer is turned off, all stored jobs will be deleted.
Printing Additional Copies Using Quick Copy
To print additional copies of a job stored in the printer:
1
Press the MENU key.
2
Press the
or
pears.
e-MPS
3
Press the
key.
4
Press the
or
Copy appears followed by the user name (Harold, in
this example). The user name is assigned at printing
using the printer driver.
>Quick Copy
Harold
5
Press the ENTER key. A blinking question mark (?)
appears before the user name.
>Quick Copy
?Harold
6
Press the
or
name, Arlen, in this example.
>Quick Copy
?Arlen
7
Press the ENTER key. The job name entered in the
printer driver (Report, in this example) appear with
a blinking question mark (?) before the letters.
1-36
Printer Driver Guide
Changing the
key repeatedly until e-MPS > ap-
>
key repeatedly until >Quick
key to display the desired user
>Arlen
?Report
8
Press the
.
tle.
9
Press the ENTER key. The number of copies to be
printed can be set. To increase the copy count, press
the
key.
>Report
Copies
Press the ENTER key to finalize the copy count. The
10
printer prints the specified number of copies for the
job.
Deleting a Quick Copy Job
All quick copy jobs are automatically deleted when the print-
er is turned off. If you desire to explicitly delete a stored quick
copy job, proceed as follows:
1
Follow steps 1 through 8 in the above section to let
the title of the job to be deleted displayed.
2
When the title of the job to be deleted is displayed,
e.g. Report, below, press the ENTER key. The cursor
below the copy count starts to blink.
>Report
Copies
3
Press the
below the title.
>Report
Delete
4
Press the ENTER key. The stored quick copy job is de-
leted.
or
key to scroll to the desired job ti-
key; to decrease the copy count, press the
001
001
key repeatedly until Delete appears
Advertisement
Table of Contents
