Setting The Character Pitch For Courier/Letter Gothic; Setting Code Set - Oce WP20 Operation Manual

Setting the Character Pitch for Courier/Letter
Gothic
You can set the character pitch for fixed-pitch fonts when the
default font is Courier or Letter Gothic.
1 Press the MENU key.
2 Press the or
pears.
Font
3 Press the key.
4 Check that Internal is displayed and press the
key.
>Font Select
Internal
5 Press the or
pears.
>Pitch
10.00 cpi
6 Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
>Pitch
10.00 cpi
7 Press the or
ue of the figure where the cursor is blinking. The
character pitch can be set between 0.44 and 99.99
characters per inch, in 0.01 character-per-inch incre-
ments. You can use the
cursor right and left.
8 When the desired size is displayed, press the ENTER
key.
9 Press the MENU key. The message display returns to
Ready.
key repeatedly until Font > ap-
>
>
key repeatedly until >Pitch ap-
key to increase or decrease the val-
and keys to move the
Chapter 1 Using the Operator Panel

Setting Code Set

You can change the character code set. Available character
code sets vary depending on the current font. (The default is
IBM PC-8.)
1 Press the MENU key.
2 Press the or
pears.
Font
3 Press the key.
4 Press the or
appears.
>Code Set
IBM PC-8
5 Press the ENTER key. A blinking question mark (?)
appears.
>Code Set
?IBM PC-8
6 Press the or
code set appears.
7 Press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
key repeatedly until Font > ap-
>
key repeatedly until >Code Set
key until the desired character
1-29