Setting Duplex Printing; Binding Setups - Oce WP20 Operation Manual

Setting Duplex Printing

NOTE
To use this function, the duplexer must be installed on the print-
er.
Using the optional duplex unit, you can automatically print
on both sides of the paper. The duplex unit is installed un-
derneath the printer. The default setting of the duplex print-
ing is None (duplex printing disabled).

Binding Setups

The term binding refers to the manner in which printed pag-
es of paper are joined together (by gluing, stitching, etc.) in
book form. The two possible types of binding are long-edge
binding, in which pages are joined together along their long
edge; and short-edge binding, in which they are joined to-
gether along their short edge. In selecting a binding type,
you must also consider the orientation of the printed page.
You can use long-edge or short-edge binding with either
landscape or portrait printing.
Depending on the binding type and print orientation, the du-
plex unit provides four types of binding setups. These are: (1)
portrait, long-edge, (2) portrait, short edge, (3) landscape,
long-edge, and (4) landscape, short-edge. The figure below
shows these binding setups.
(1)
Portrait,
long-edge
(3)
Landscape,
long-edge
Binding Setups
To select duplex printing and binding setup from the opera-
tor panel, proceed as follows.
1 Press the MENU key.
2 Press the or
Handling > appears.
Paper Handling >
3 Press the key.
(2)
Portrait,
short-edge
Landscape,
short-edge
(4)
key repeatedly until Paper
Chapter 1 Using the Operator Panel
4 Press the or key repeatedly until >Duplex
Mode appears.
>Duplex Mode
None
Press the ENTER key. A blinking question mark (?)
5
appears.
>Duplex Mode
?None
6 Press the or key to display the desired duplex
mode. The display changes as shown below.
None (default)
Short edge bind
Long edge bind
When the desired duplex mode displayed, press the
7
ENTER key.
8 Press the MENU key. The message display returns to
Ready.
1-23