Table of Contents
Advertisement
Chapter 1 Using the Operator Panel
>Cassette Size >
Custom
Selecting Paper Size Unit for the Paper Cassette
Set the paper size unit as described below when Custom is se-
lected.
1
When the paper size is set to Custom, press the
key.
2
>>Unit appears and the unit currently set is dis-
played. You can select from mm and inch. The de-
fault setting is mm.
>>Unit
mm
3
Press the ENTER key. A blinking question mark (?)
appears.
>>Unit
? mm
4
Press the
or
5
Press the ENTER key.
Entering the Width and Length
Then, use the following procedure to set the paper size when
the paper size is set to Custom.
1-16
key to select mm or inch.
1
When the unit of measurement is set, press the
key. >>X Dimension appears (the paper width set-
ting).
>>X Dimension
297 mm
2
Press the ENTER key. A blinking cursor (_) appears.
>>X Dimension
297 mm
3
Press the
or
key to increase or decrease the
value of the figure where the cursor is blinking and
display the desired width. The width can be set be-
tween 148 and 297 mm (5.83 to 11.69 inches). You
can use the
and
and left.
4
Display the paper width and press the ENTER key.
5
When the width is set, press the
sion appears (the paper length setting).
>>Y Dimension
432 mm
6
Press the ENTER key. A blinking cursor (_) appears.
>>Y Dimension
432 mm
7
Set the desired length in the same way as you set
the paper width. The length can be set between 210
and 432 mm (8.27 to 17.01 inches).
>>Y Dimension
432 mm
8
Display the paper length and press the ENTER key.
9
Press the MENU key. The message display returns to
Ready.
keys to move the cursor right
key. >>Y Dimen-
Advertisement
Table of Contents
