Fire-Lite Alarms MS-9600LS Manual page 54

Installation
8. Reinstall Keypad/Display on the main circuit board by positioning the unit over the
appropriate standoffs and securing with screws which were loosened in step 3
9. Remount the main circuit board assembly to the chassis using screws and standoffs in their
original locations. Plug in the power supply cable at J1 on the main circuit board
10. Make certain to program the control panel for DACT-UD2 operation
11. Refer to the Telephone Requirement and Warnings section of the DACT-UD2 Installation and
Programming Manual Document #53037, before proceeding with this step. Connect the
premises primary and secondary phone lines to the DACT-UD2 as illustrated in Figure 2.14
and test the system for correct operation
54
Figure 2.13 DACT-UD2 Installation on Standoffs
Optional Modules and Devices
Mounting Screw
male/female standoff
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
Mounting Screw