Zones Available - Fire-Lite Alarms MS-9600LS Manual

Programming
ZONE TYPE PROG
1=MONITOR
2=SMOKE PHOTO
3=WATERFLOW
Zone Type Program Screen #1
ZONE TYPE PROG
1=MEDICAL
2=HAZARD
3=TAMPER
Zone Type Program Screen #3
ZONE SETUP
1=ZONE TYPES

2=ZONES AVAILABLE

3=ZONE MESSAGE
Zone Setup Screen #3
148
Zone types can be changed by pressing the keypad number key corresponding to the zone in each
Zones Installed Screen. Available zone types will be displayed in the resultant screens. For exam-
ple, to change the zone type for zone Z02 in the screen illustrated above, press 3. The following
screens will be displayed:
To change the zone type for Z02 to Pull Station, scroll the display until Zone Type Program Screen
#2 is displayed. Press 2 to program zone Z02 as a Pull Station zone. The display will return to the
Zones Installed Screen showing zone Z02 and the Pull Station program type. Repeat the procedure
for each zone to be changed.
IMPORTANT! In Zone Type Program Screen #1, selecting WATERFLOW will assign a Water-
flow silenceable zone type to the selected zone. Any signaling devices programmed to the same
zone can be silenced by pressing the Alarm Silence key or by using the auto-silence feature.
To program a waterflow circuit as nonsilenceable, refer to "System Setup" on page 100.
NOTE: Zone Types are only relevant for Central Station reporting. Changing a zone type will
change how it is reported to the Central Staion.
Zones Available
Pressing 2 while viewing Zone Setup Screen #3 will display the following screen:
01 02 03 04 05 06 07
08 09 10 11 12 13 14
15 16 17 18 19 20 21
The display will show all of the zones that are still available for programming. Note that an up
and/or down arrow may appear in the upper right corner of the display, indicating that additional
screens of zone information exists. Press the up or down arrow key to view additional screens.
ZONE TYPE PROG
1=HEAT
2=PULL STATION
3=DUCT
Zone Type Program Screen #2
ZONE TYPE PROG
1=SUPERVISORY
2=PROC. MON
3=SMOKE ION
Zone Type Program Screen #4
ZONES AVAILABLE
MS-9600LS Series Manual — P/N 52646:B2 2/12/2010
Maintenance Programming Level
only