Transport And Shipping; Installation; Overview Of Installation - Meiko K-200 Owner's Installation, Operation And Maintenance Manual

S 2 - T
ECTION RANSPORT AND
2 T
RANSPORT AND
IMPORTANT
• Observe any notices on the crating
material that pertain to shipping.
• Use care when transporting the equipment.
• As you unpack the equipment, check that
all components shown on the shipping
invoice are present and intact. Be sure to
check for shipping damage. If shipping
damage is present, call Meiko Customer
Service at 1-800-868-3840, providing full
details on the customer, serial number and
extent of damage present. Meiko will file
a freight claim based on this information.
WARNING!
In NO EVENT should a damaged
appliance be installed or operated!
Page 4
S
HIPPING
S
HIPPING
3 I
NSTALLATION

3.1 Overview of Installation

Prior to installation, the factory will supply
engineering drawings detailing the machine.
Details include dimensions and complete
utility requirements.
All installations of new Meiko K-Tronic series
rack conveyors will include a factory
representative as a supervisor and advisor.
The factory representative will be able to
advise the installer of special installation
requirements that are outside the scope of
this Manual.
The owner should contract with qualified
personnel to move the appliance to the
installation location, unpack it, and prepare it
for final utility connections.
In most cases, local codes prevent the final
utility connections from being made by any
party other than a licensed electrician,
plumber and/or steam fitter.
IMPORTANT
It is the responsibility of the owner to ensure
that all aspects of the installation comply with
all applicable local and national codes.
IMPORTANT
The appliance's warranty is not valid until a
Meiko Authorized Service Agent performs a
Performance and Installation Inspection.
Installation of the dishwasher involves the
following steps:
• Verifying that the utility connections are
present, are appropriate for the appliance,
and comply with all applicable local and
national codes.
• Unwrapping the appliance (leaving the
shipping skid in place for easier
movement) and checking for shipping
damage.
• Moving the appliance to the installation
location, removing the skid, and leveling
the feet.
• Connecting the machine to tabling.