Meiko K-200 Owner's Installation, Operation And Maintenance Manual page 7

Figure 3-2: Removing the end cowling (if required)
Threaded studs
on back of
cowling
Qty. 16
10. Using a spirit level on the conveyor track,
check that the appliance is level in both
directions (front-to-back AND side-to-
side). If necessary, level the appliance by
rotating the bottom section of each foot
as necessary using a 27mm open-ended
wrench. See Figure 3-3.
CAUTION
The dishwasher MUST be level for proper
operation.
Figure 3-3: Leveling
Rotate bottom
section of foot
to adjust height
With cowling
removed, set
machine into
place between
Gasket
Cowling
Reach through
rack opening to
access acorn
nuts and washers
11. Check the tension on each foot section to
12. If you removed a cowling from the
13. Run a fine bead of clear silicone sealant
tables
ensure that the legs are sharing the load
evenly. An unbalanced section may cause
water leaks, incorrect operation (by
allowing the machine to shift position),
and/or damage the legs.
machine in Step 9, replace it on the
machine at this time. Be sure to check that
the rubber gasket that fits between the
cowling and the body of the machine is
properly seated.
along the top edge of the seam between
the cowling and the machine.
S 3 - I
ECTION NSTALLATION
Replace
cowling
Page 7