Meiko K-200 Owner's Installation, Operation And Maintenance Manual page 19

A - POWER ON button
Switches the machine on and begins
the filling and heating process.
B - START OPERATION button
Starts the conveyor drive and wash
pumps in operation. This button also
begins to circulate water through the machine
to allow the Waste Air Heat Recovery System
to operate.
C - STOP OPERATION button
Press during idle periods to shut off
the wash pumps and conveyor drive.
The tank heaters will maintain tank
temperature to allow for fast recovery.
D - POWER OFF button
Switches off the machine.
E, F, G - CYCLE SELECT keys
Each key selects a different conveyor speed
to accomodate different levels of soiling:
Fast - for typically soiled items
Medium - for items with greater
amounts of soiling
Slow - for very heavily soiled items
H - EMERGENCY STOP button
Stops the conveyor and wash
pumps immediately. Once it is
pressed, the emergency stop
button must be reset (by pulling
it back out) before the machine can return to
operation.
I - LCD Display
Provides
about the dishwasher,
including operating status, tank temperatures, etc.
The temperatures shown in the display are:
• WT1 - Wash Tank 1
• WT2 - Wash Tank 2 (K-400 series only)
• PAR - Pumped Auxiliary Rinse zone
• FR - Final Rinse zone
J - Directional keypad
Only used by service agents
during programming and
diagnostics.
K - Infrared communications port
Only used by service agents during
programming and diagnostics.
L - ERROR light
Illuminates (red) if a problem occurs
with the dishwasher. An error code
and description of the problem will appear in
the LCD display.
M - Not used
N - Drain handles
Open and close the machine drain.
Each tank (prewash, 1-2 wash tanks,
auxiliary rinse tank) has its own drain handle
that feeds into the single-point machine drain.
The tanks can be drained individually if
desired.
S 4 - O
ECTION PERATION
information
Page 19