Introduction; Overview Of Equipment; General Safety Information; Transport And Shipping - Meiko FV 40.2 G Owner's Installation, Operation And Maintenance Manual

1 I
NTRODUCTION

1.1 Overview of Equipment

The MEIKO Model FV 40.2 G is a commercial
glasswasher designed for cleaning glassware,
dishes, cutlery and kitchen utensils with a
minimum of employee intervention or
supervision.
A control keypad allows easy selection of three
different dishwashing cycles to accommodate
different levels of soiling. A digital display
permits easy monitoring of operation.
Other features of the unit that affect operation
include:
Auto Safe - An internal booster heater is
regulated by the electronic control system to
ensure a proper sanitizing final rinse
temperature, regardless of the incoming water
temperature.
Soft Start - The wash water is pumped at a
reduced pressure for the first few seconds of
the wash cycle. This protects the ware from
being moved or damaged by a sudden burst
of pressure.
Pumped Rinse - An internal rinse pump
ensures that the final rinse pressure is
constant.
Pumped Drain - Accommodates wall or floor
drains.
Aqua Stop - The unit will automatically shut
down if a water leak is detected.
For efficient and SAFE operation, be sure to
follow the installation and operating
instructions provided in this manual. In
particular, all safety symbols and notices on
the equipment and in the supplied
documentation must be followed.
IMPORTANT
The Model FV 40.2 G glasswasher has been
designed exclusively for the washing of
glassware, dishes, cutlery and kitchen utensils
in a commercial or institutional setting and must
not be used for any other purpose.

1.2 General Safety Information

The following symbols and headings are used
throughout this manual to indicate possible haz-
ards to persons or to the equipment. The sym-
bols and headings are shown in order of impor-
tance. The descriptive text following these head-
ings is italicized for easy recognition.
WARNING!
CAUTION
IMPORTANT
NOTE
2 T
RANSPORT AND
CAUTION
During shipping and installation, the
glasswasher may ONLY be positioned upright
or on its left side. Some water may remain in
the lines after pre-shipping testing. If the unit
is positioned in any manner EXCEPT upright
or on its left side, this water can affect the
operation of the water level sensor.
IMPORTANT
• Observe any notices on the crating
material that pertain to shipping.
• Use care when transporting the
equipment.
• As you unpack the equipment, check that
all components shown on the shipping
invoice are present and intact. Be sure to
check for shipping damage. If shipping
damage is present, call MEIKO Customer
Service at 1-800-868-3840, providing full
details on the customer, serial number and
extent of damage present. MEIKO will file
a freight claim based on this information.
WARNING!
In NO EVENT should a damaged
appliance be installed or operated!
S 1 - I
ECTION NTRODUCTION
Possible hazard to per-
sons, such as from elec-
trical shock, crushing, or
hot surfaces.
Possible hazard to the
glasswasher or to other
equipment.
Vital information or tips for
the installer or operator.
Information or tips for the
installer or operator.
S
HIPPING
Page 3