Meiko K-200 Owner's Installation, Operation And Maintenance Manual page 27

Upper
manifolds
Push lever up
to release
manifold
manifold
To reinstall, seat the water inlet at the back of the manifold firmly
onto the water supply tube. Then, push the front of the manifold
up until it snaps into place.
Single or dual upper or lower prewash arms
(K-200 PW, K-400 PW only)
Rotate arm counter-
clockwise to free
the locking pin,
then pull out
To reinstall, seat the back end of the arm in its socket, then rotate
it clockwise to lock it in place.
Figure 5-2: Arm removal
Pull
out
Lower
manifolds
Pull manifold forward
to release it, then lift
up and out
To reinstall, slide the manifold into its track, checking that the
front support clips are seated properly on their rails. Then, push
the manifold back until it snaps into place.
Upper final rinse
To reinstall, seat back of each arm in its socket, then push front
into place. Arms shown are for a Left-to-Right machine. Right-to-
Left arms are a mirror image.
Lower final rinse
To reinstall, seat back of each arm in its socket, then push front
into place. Arms shown are for a Left-to-Right machine. Right-to-
Left arms are a mirror image.
S 5 - C
ECTION LEANING
Upper auxiliary rinse
Lower auxiliary rinse
Page 27