Drain Connection; Final Assembly - Meiko K-200 Owner's Installation, Operation And Maintenance Manual

3.15 Drain Connection

IMPORTANT
In some cases, local codes dictate that drain
connections be made only by a certified
professional.
The machine is equipped with a 2-15/16"
(75mm) OD vertical, gravity-fed drain. The
machine requires a 4" or larger floor drain.
See Figure 3-13.
1. In some cases, a grease trap (supplied
by others) must be fitted into the waste
water line. If a trap is required for your
installation, check that it is present.
2. If possible, the machine drain can simply
be positioned directly above a floor drain,
as shown in Figure 3-13.
3. If a floor drain is not directly beneath the
machine drain, or if local codes require a
trap, a drain line can be attached using
the supplied rubber boot and clamp. Using
the boot and clamp, the machine drain can
be connected either to a 3" OD drain line,
or to a 3" NPT pipe (using the supplied 3"
NPT adapter). Choose a piping material that:
• Complies with any applicable local and
national codes.
• Is rated for use with water temp-
eratures up to 180°F.
• Is rated for 3-12 pH to accommodate
detergents and rinse aid in the drain water.
Load end of
machine
Figure 3-13: Drain connection
If it is
necessary to
re-route the
drain line:
If possible, the
machine drain
can be positioned
directly above 4"
or larger floor
drain.
3" NPT adapter
(supplied)- connect
to 3" NPT line
(supplied by others)

3.16 Final Assembly

1. Check and tighten all electrical terminal
screws.
2. Check that all tools, hardware, metal shav-
ings or filings, etc. are removed from in-
side the machine.
3. Replace all panels onto the warewasher.
4. Check that the wash arm manifolds, scrap
screens, curtains, and all other removable
components are correctly installed in the
machine.
5. Check that the front access door(s) are
closed.
6. Switch the circuit breaker/fused discon-
nect to the ON position.
7. Press the button. Allow the machine
to fill.
8. Wait for the LCD display to show "Ready
for operation," showing that the tanks are
filled and heated.
9. Press to start the wash pumps. As the
water circulates through the machine, the
final rinse water will heat to the correct
temperature.
10. When the LCD display reads "Cycle
Pause," load several empty racks into the
machine.
Machine
drain
Rubber
boot
(supplied)
Clamp
(supplied)
Direct connection
to 3" OD drain line
(supplied by others)
S 3 - I
ECTION NSTALLATION
Page 15