Clearing Jams; Shutdown - Meiko K-200 Owner's Installation, Operation And Maintenance Manual

4.6 Clearing Jams

Under normal operating conditions, racks will
not jam as they move through the machine.
However, improper loading or improper
curtain installation may cause a rack to jam.
If the conveyor jams, the ERROR
light will begin flashing and the
machine will stop operating.
To clear a jam:
Press the ERROR button to
acknowledge the error. The flashing
light above the button should turn off.
Press the POWER OFF button.
Open the front door(s) to access the jammed
rack(s).
WARNING!
When the front access doors are
opened, steam will escape the interior
of the machine.
WARNING!
Before clearing a jam, ALWAYS press
the POWER OFF button.
IMPORTANT
Once a conveyor jam is detected and the
ERROR light begins to flash, the error cannot
be cleared unless the machine is turned off
briefly. This is intended to discourage
operators from leaving the machine in
operation while clearing a jam.
If the ERROR light remains flashing after a
jam has cleared, briefly press
then to reset the machine.
After the jam has been cleared, restart the
machine normally following the procedure in
Section 4.2, Startup.

4.7 Shutdown

Check that the last rack has exited the
machine.
Move the drain handles to the DRAIN OPEN
position.
Switch the master circuit breaker/fused
disconnect to the OFF position.
Open the front access door(s). Clean the
machine as described in Section 5, Cleaning.
Meiko recommends that the door of the
, then ,
dishwasher be left open overnight to allow it
to air thoroughly.
S
Press the STOP OPERATION
button.
Press the POWER OFF button.
WARNING!
When the front access doors are
opened, steam will escape the interior
of the machine.
WARNING!
For your safety, allow the interior of the
machine to cool before cleaning.
4 - O
ECTION PERATION
Page 23