Table of Contents
Advertisement
Reset command
Description Resets the switch configuration parameters. If you omit the operand, the default is Reset Switch.
Authority Admin session
Syntax
reset
cim
config [config_name]
factory
port [port_number]
radius
security
services
snmp
switch (default)
system
zoning
Operands
cim
Resets cim configuration to default values.
config [config_name]
Resets the configuration given by [config_name] to the factory default values for switch, port, port
threshold alarm, and zoning configuration as described in
[config_name] does not exist on the switch, a configuration with that name will be created. If you
omit [config_name], the active configuration is reset. You must activate the configuration for the
changes to take effect. for switch, port, and port threshold alarm configuration default values.
factory
Resets switch configuration, port configuration, port threshold alarm configuration, zoning
configuration, SNMP configuration, system configuration, security configuration, RADIUS
configuration, switch services configuration, and zoning to the factory default values as described
in
Table 35
port [port_number]
Re-initializes the port given by [port_number]. External ports are numbered 0 and 9; internal
ports are numbered 1–8.
radius
Resets the RADIUS configuration to the default values as described in
security
Clears the security database and deactivates the active security set. The security configuration
value, autosave, and fabric binding remain unchanged.
services
Resets the switch services configuration to the default values as described in
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
configuration default values.
switch
Resets the switch without a POST. This is the default. This reset disrupts traffic and does the
following:
• Activates the pending firmware
• Closes all management sessions
• Clears the event log. To save the event log before resetting, refer to the Set Log command
To reset the switch with a POST, refer to the Hardreset command. To reset the switch without
disrupting traffic, refer to the Hotreset command.
144 Command Line Interface
through
Table
43. The switch configuration is activated automatically.
Table 35
through
Table
Table
40.
Table
41.
Table 39
38. If
for SNMP
Advertisement
Table of Contents
