Table of Contents
Advertisement
Examples The following is an example of the Image Install command:
See also
Firmware Install
138 Command Line Interface
McDATA4GbSAN (admin) #> image install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account
: johndoe
IP Address
: 10.20.33.130
Source Filename : 5.2.00.11_mpc
About to install image.
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
command, page 126
Do you want to continue? [y/n] y
Advertisement
Table of Contents
